National Instruments cFP-20xx Manuel d'utilisateur télécharger pdf (Page 13)

I. Enter an IP address for the Time Server on the

Servers tab of the System Configuration dialog box,

shown in the figure at right.

The time server is a networked computer that runs

the National Instruments Time Service installed by

FieldPoint Explorer. Enter the IP address of the PC

you are using. When you finish configuring the

controller, the time has been set and Time Server is

not a required parameter. The cFP-20

has an

internal battery-backed clock that provides

consistent timestamps in the absence of a time server.

J. Click

OOKK

in the System Configuration dialog box. Click

YYeess

when prompted to reboot the

cFP-20

When the cFP-20

reboots, it should appear in Remote System Explorer with the updated IP

address and comment, as shown in the following figure. If it does not appear, select

VViieeww»»RReeffrreesshh

or refer to the user manual.

K. Highlight the serial number and click

SSeelleecctt

. When the new host name or IP address

appears in the Comm Resource Configuration dialog box of FieldPoint Explorer, you can

configure your devices and channels.

cFP-20xx Quick Start Guide

National Instruments Corporation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

National Instruments cFP-20xx Manuel d'utilisateur Page 13