National-instruments Graphical User Interface Ultiboard Manuel d'utilisateur télécharger pdf (Page 245)

Appendix A Menus and Commands

NI Ultiboard User Manual A-4 ni.com

Edit»Cut

Removes the selected element(s) from the board. The element is placed on

the Windows Clipboard and can be pasted again.

Edit»Copy

Copies the selected elements and stores them on the Windows Clipboard so

they can be pasted again.

Edit»Paste

Pastes the item on the Windows Clipboard to its original layer (regardless

of what layer is currently active). Creates new duplicate object(s) without

the netlist information. New parts will have Reference Designators that

increment from the next available for that part type. For example, if the last

resistor was R34, and a resistor is pasted, its Reference Designator will be

R35.

Edit»Paste Special

• Paste with Net—Pastes the item on the Windows Clipboard into the

design with the same connectivity as the source. New parts will have

Reference Designators that increment from the next available for that

part type.

• Paste to Active Layer—Pastes the item on the Windows Clipboard to

the active layer (regardless of what layer it originally resided on).

Edit»Delete

Use to delete the selected design elements. You are prompted to confirm the

deletion.

Edit»Copper Delete

Deletes open trace ends, unused vias, or all copper elements:

• All Copper—Use to delete all copper in the design, including traces,

copper areas, and powerplanes. Refer to the Deleting All Copper

section for more information.

• All Teardrops—Use to delete all teardrops on your design. Refer to

the Adding and Removing Teardrops section of Chapter 5, Working

with Traces and Copper, for more information.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 280 281

Pas de commentaire

National-instruments Graphical User Interface Ultiboard Manuel d'utilisateur Page 245