National-instruments Graphical User Interface Ultiboard Manuel d'utilisateur télécharger pdf (Page 42)

Chapter 1 User Interface

NI Ultiboard User Manual 1-26 ni.com

Setting Favorite Layers

You can assign shortcuts for up to ten layers using the Favorite layers tab.

These shortcuts can then be used to make a layer active. The active layer is

the layer where any new elements will be placed, or where any deletions

will be made.

Complete the following steps to assign shortcut numbers to layers:

1. Click on the Favorite layers tab.

2. Select the desired layer from the drop-down list beside each layer

number. For example, you may wish to assign Layer 2 to the

Copper Bottom layer.

3. Click OK.

To make a layer active, press <Ctrl-Alt-layer number> on your keyboard.

The layer becomes active and is highlighted in the Layers tab of the Design

Toolbox.

In the above example, pressing <Ctrl-Alt-2> on your keyboard makes the

Copper Bottom layer active.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 280 281

Pas de commentaire

National-instruments Graphical User Interface Ultiboard Manuel d'utilisateur Page 42