National Instruments cFP-PWM-520 Manuel d'utilisateur télécharger pdf (Page 2)

FP-PWM-520 and cFP-PWM-520 2 ni.com

Installing the FP-PWM-520

The FP-PWM-520 mounts on a FieldPoint terminal base

(FP-TB-x), which provides operating power to the module.

Installing the FP-PWM-520 onto a powered terminal base does

not disrupt the operation of the bank.

To install the FP-PWM-520, refer to Figure 1 and complete the

following steps:

1. Slide the terminal base key to either position X, used for any

module, or position 4, used for the FP-PWM-520 module.

2. Align the FP-PWM-520 alignment slots with the guide rails on

the terminal base.

3. Press firmly to seat the FP-PWM-520 on the terminal base.

When the module is firmly seated, the terminal base latch locks

it into place.

Figure 1. Installing the FP-PWM-520

1 I/O Module

2 Terminal Base

3 Alignment Slot

4 Terminal Base Key

5 Latch

6 Guide Rails

1 2 3 4 5 6 7 ... 18 19

Pas de commentaire

National Instruments cFP-PWM-520 Manuel d'utilisateur Page 2