National Instruments cFP-DO-403 Manuel d'utilisateur télécharger pdf (Page 2)

[c]FP-DO-403 2 ni.com

2. Align the FP-DO-403 alignment slots with the guide rails on

the terminal base.

3. Press firmly to seat the FP-DO-403 on the terminal base. When

the module is firmly seated, the terminal base latch locks it into

place.

Figure 1. Installing the FP-DO-403

Installing the cFP-DO-403

The cFP-DO-403 mounts on a Compact FieldPoint backplane

(cFP-BP-x), which provides operating power to the module.

Installing the cFP-DO-403 onto a powered backplane does not

disrupt the operation of the bank.

To install the cFP-DO-403, refer to Figure 2 and complete the

following steps:

1. Align the captive screws on the cFP-DO-403 with the screw

holes on the backplane. The alignment keys on the

cFP-DO-403 prevent backward insertion.

2. Press firmly to seat the cFP-DO-403 on the backplane.

3. Using a number 2 Phillips screwdriver with a shank of at least

64 mm (2.5 in.) length, tighten the captive screws to 1.1 N ⋅ m

(10 lb ⋅ in.) of torque. The nylon coating on the screws prevents

them from loosening.

1 I/O Module

2 Terminal Base

3 Alignment Slot

4Key

5 Latch

6 Guide Rails

1 2 3 4 5 6 7 ... 14 15

Pas de commentaire

National Instruments cFP-DO-403 Manuel d'utilisateur Page 2